Minnippi Golf & Range — Fibre Repair, Testing, and Certification for Lynx Electrical

Lynx Electrical noticed a damaged fibre cable at Minnippi Golf & Range. Instead of waiting to see whether it would hold, they called in Total Fibre & Data for fibre repair in Brisbane straight away. We resliced the damaged run and tested four additional runs across the site as a precaution. Once every run passed, we certified the network on completion.

The Job

Lynx Electrical, an electrical contractor working at Minnippi Golf & Range, engaged us after identifying a damaged fibre cable on site. Rather than attempt the repair themselves, Lynx brought us in to diagnose and fix it properly. They also wanted us to confirm the rest of the network wasn’t carrying the same risk.

Fibre Repair on the Known Fault

We resliced the damaged run using fusion splicing, which aligns the fibre cores precisely and restores the connection to full performance. We do not use mechanical splicing on commercial work.

Testing Beyond the Known Issue

One damaged cable was the reason we were called in, but that wasn’t where Lynx stopped. While we were on site, Lynx also asked us to test four additional runs across the network as a precaution, not because anything had failed. Specifically, this involved:

• OTDR testing on each run to check signal loss and continuity
• Identifying any run performing below spec, even without an active fault
• Resplicing or repairing anything that didn’t test clean
• Certifying every run once it passed

The Outcome

In total, we resliced two runs and confirmed three clean on test. As a result, the network at Minnippi Golf & Range is now fully tested and certified, not just repaired at the point of the original fault.

Specialist Fibre Repair Support for Brisbane Electrical Contractors

We’re regularly brought in by electrical contractors like Lynx. Sometimes we handle the fibre and data side of a job directly. Other times we step in when something outside their scope needs a specialist. This project is a working example. A contractor identified an issue early and brought in a specialist to fix it and verify the rest of the network, rather than leaving it to chance.

In short, Total Fibre & Data is a licensed electrical and communications contractor. We deliver fibre optic installation, splicing, and testing and certification services across Brisbane and South East Queensland, including white-label services for electrical, IT, and security contractors.

FAQ

Why would a contractor call in a specialist for one damaged cable instead of fixing it themselves?

Fibre repair requires fusion splicing equipment and OTDR testing to confirm the fix actually meets spec. Contractors who don’t run fibre day-to-day often bring in a specialist to handle it properly and certify the result.

Why test runs that hadn’t shown any fault?

One fault is a reasonable prompt to check whether others are at risk, especially if the runs were installed or exposed under similar conditions. Testing confirms it either way, rather than leaving it to chance.

Do you work alongside electrical contractors as part of their own quality checks?

Yes. We’re regularly brought in by electrical contractors to handle the fibre and data side of a job, including repairs, testing, and certification, under white-label support if needed.

Do you provide fibre installation and testing services in Brisbane?

Yes. Total Fibre & Data delivers fibre installation, splicing, and testing and certification services across Brisbane and South East Queensland.

Need to modernise your network infrastructure? 
Partner with Total Fibre & Data for certified design, installation, and commissioning services. 
Contact us today to discuss your project requirements.